Upgrade to lineage harvester 1.3.0 and newer

The lineage harvester 1.3.0 enables you to connect to a Collibra Data Lineage server, based on your geolocation and cloud provider.

You only have to follow this upgrade procedure when you upgrade from lineage harvester 1.2.1 or older to lineage harvester 1.3.0 or newer or any time the server's geolocation or cloud provider changes.

Tip We highly recommend that you always use the newest lineage harvester.

Steps

1. If you have strict firewall rules, whitelist one of the following IP addresses, based on your Collibra geolocation and cloud provider:

   • 18.198.89.106 (techlin-aws-eu)
   • 54.242.194.190 (techlin-aws-us)
   • 15.222.200.199 (techlin-aws-ca)
   • 35.205.146.124 (techlin-gcp-eu)
   • 34.73.33.120 (techlin-gcp-us)
   • 35.197.182.41 (techlin-gcp-au)

   • 34.152.20.240 (techlin-gcp-ca)

2. Download lineage harvester 1.3.0 or newer, from the Collibra Downloads page.
3. Install the lineage harvester.
4. Migrate the data sources in your old configuration file to the configuration file in the new lineage harvester folder.
5. If your old configuration file had a techlin section, remove this section and all its properties.
6. Optionally, add or remove data sources in your lineage harvester configuration file.
7. Use the full-sync command to synchronize all data sources in your configuration file.
   The lineage harvester uploads your data sources to the Collibra Data Lineage server with the new IP address.
   Note If you have previously ingested Power BI, you must run the Power BI harvester again before you run the lineage harvester.

What's next?

You can now access your technical lineage via a Column, Table, Power BI Column or Looker Look asset page.